Need a cuemaker to finish a butt blank to fit Mezz shafts

[cwong79]

Have a full splice blank. Would like some inlays on points and joint/buttcap. Needs to fit a uni-lock Mezz ignite shaft. I can provide a butt for measurement references.

 

[Kim Bye]

Have a full splice blank. Would like some inlays on points and joint/buttcap. Needs to fit a uni-lock Mezz ignite shaft. I can provide a butt for measurement references.

Maybe you could tell us more what type of inlays you want and is your blank oversized and who made it?
You say it needs to fit a Uni-Loc Ignite shaft?
Ignite does not come in Uni Loc, so is the shaft converted or are you talking about the Mezz United Joint pin?

 

[cwong79]

It’s an oversized blank by Rounceville.

I would like a single card suits within every point. Diamond, spade, heart, etc. With this type of paua inlay ~

https://luthiersupply.com/121/292/pr...nlay-0180.html

Joint and buttcap from buffalo horn with paua inlay. Kinda like what Ed Prewitt does.

Here is the joint type,

http://mezzcue.com/en/technology_pool/joint/united_joint

Maybe you could tell us more what type of inlays you want and is your blank oversized and who made it?
You say it needs to fit a Uni-Loc Ignite shaft?
Ignite does not come in Uni Loc, so is the shaft converted or are you talking about the Mezz United Joint pin?