Need a shaft that will fit my Bender

Good luck. I dont think any other current maker uses Bender's pin--though I believe Omega/DPK did (not surprising, since Bender started out there).
 
I can make one for you. $80 unless you want a layered tip or ivory ferrule. I actually have a Bender on the way to me for two new 314-2 shafts.

PM me if you need any info.
 
duke@neo.rr.com said:
I've never heard of 3/8x14
Click to expand...

This doesn't surprise me ...

Poolshootingdon, Royce at OB-1 made me a shaft with 3/8x14 thread ... but it's slightly more than $80 Ryan is quoting you .. that's cheap!!!
 
You must log in or register to reply here.
Back
Top