Need help. What kind of cue is this?

[cuenut]

I just picked this cue up in the Oklahoma City area. The cue is not marked, but is constructed very well. Solid block ivory joint, 3/8X10 pin that is a little shorter than most other big pin cues I have owned (about 3/4 the length of a McDermott pin). The points are very even and the veneers are laid out like a Southwest (laid into the "V" groove at 90 degrees instead of mitered at 45). Ivory inlays in the butt with delrin butt cap. It came with two shafts in an older It's George case. Thanks for any help you may provide.

 

[thepavlos]

If its locally made check with Jim Ingram; it could be a Horn as well, just some ideas.
Paul

 

[cueman]

I will add a guess of John Guffey to the above two suggestions.
Chris
www.cuesmith.com
www.internationalcuemakers.com

 

[cuenut]

Thanks for the input. I thought that the short pin would maybe give it away. I also looked through the BB and found these other cuemakers in that area: Auerbach, Baker, Farris. I'll give them all a try. Thanks again.