points/forearms

[slim123]

When making a prong, are you cuemakers using the same taper for just the prong as you would for a full butl but for instance .200

 

[BarenbruggeCues]

That would be a negative. Shorter distance between centers will have a different degree of angle.

 

[slim123]

That would be a negative. Shorter distance between centers will have a different degree of angle.

Thank you i thought so , i'm figuring it out

 

[cueman]

Most of us just use a taper bar which holds the same angle no matter the length. But if you are offsetting the tailstock it is basically .0069 offset per inch.

 

[slim123]

Most of us just use a taper bar which holds the same angle no matter the length. But if you are offsetting the tailstock it is basically .0069 offset per inch.

Thanks Chris i was guessing pretty close, now i have a reference point