Over the years, I have had many tables and had them professionally installed. I would say that about half the time the installer did what I consider to be a good job. I watched them all do it and from watching I know how it is done. They all seem to have a little different technique and some of them did horrible job and I had to have it fixed.
I would like to know if there are any good video's on installing tables? I would like to setup a Connelly that I just got myself. I am very technically minded and very precise. I used to work in the semiconductor industry and the machines I worked on had to be level to the micron range. So I think I can do a great job and would like to give it a go.
I would like to know if there are any good video's on installing tables? I would like to setup a Connelly that I just got myself. I am very technically minded and very precise. I used to work in the semiconductor industry and the machines I worked on had to be level to the micron range. So I think I can do a great job and would like to give it a go.