S. Florida Table mech

Following up. A few bangers... I mean players took on the project and asked me to pitch in. From experience I decided to not get involved for a few reasons. I did suggest that they instruct the Tech to not use staples or screws on the exposed pocket area. Do not use V cuts when wrapping the cloth around the pockets. (However they will do whatever they have been doing)
Results ...largest V cuts I've ever seen. Exposed staples and brads. The bed seems to be ok.
The pocket liners were replaced to accommodate more balls. They are deeper....but pocket width increased to about 5.5" wide.
The installer obviously never learned from the right people. Also his best customer is the uneducated player that does not know the difference. The guys in the room are happy... who am I to criticize😂
 
Last edited:
GoldCrown said:
Tech's name please.... just curious. As for None Better...what makes him get that rating?
Click to expand...
Brett Giesler. Personal opinion. Was recommended to me by several rooms in South Florida. Delivered and setup a GC3 for me, extended the rails, new cushions, and Simonis 860. On time, pleasant, patient with my questions. I looked at the work done by several other installers and felt that they were sub par to Brett‘s quality and attention to detail.
 
You must log in or register to reply here.
Back
Top