I wasn't going to do this - however......
I have an unknown (fairly sure it is not a Brianna) Jump Break butt I picked up in a recent trade. I do know the pin size - 5/16X18 on both sections. The points appear to be spliced and match up fairly evenly within a sixteenth of an inch or so. The forearm appears to be nicely figured maple. The finish is nicked and dinged in several places - but there are no deep gouges. It needs a refinish - or just a shaft and a bumper to be bar played. This Butt weighs in at 14.9 ounces and a balance point at 18.5 inches (without the bumper and using the original 4.2 oz warped shaft).
The Butt sleeve section appears cored with no weight bolt - and is missing a rubber bumper. I think the Prather #9 push in bumper will fit - but I have not spent the three dollars as yet. The mean average of the bumper hole diameter is 0.570. If you have a flush faced 5/16X18 shaft laying around that is approximately 0.860 at the joint including the finish - you'll have a winner.
I will take *****SOLD***** shipped and am open to all trades. One fat hen and a couple of ducks? If you know who made this - please chime in.
Thanks for viewing my post.
I have an unknown (fairly sure it is not a Brianna) Jump Break butt I picked up in a recent trade. I do know the pin size - 5/16X18 on both sections. The points appear to be spliced and match up fairly evenly within a sixteenth of an inch or so. The forearm appears to be nicely figured maple. The finish is nicked and dinged in several places - but there are no deep gouges. It needs a refinish - or just a shaft and a bumper to be bar played. This Butt weighs in at 14.9 ounces and a balance point at 18.5 inches (without the bumper and using the original 4.2 oz warped shaft).
The Butt sleeve section appears cored with no weight bolt - and is missing a rubber bumper. I think the Prather #9 push in bumper will fit - but I have not spent the three dollars as yet. The mean average of the bumper hole diameter is 0.570. If you have a flush faced 5/16X18 shaft laying around that is approximately 0.860 at the joint including the finish - you'll have a winner.
I will take *****SOLD***** shipped and am open to all trades. One fat hen and a couple of ducks? If you know who made this - please chime in.
Thanks for viewing my post.
Last edited: