where to buy 3/8-14 FEMALE JOINT PIN?

cuemaker03 said:
Where can I buy the tap for 3/8-14?
Click to expand...

Someone said that Atlas carries them but I don't know if it's the right one or not, I have all of my taps made by Widell and North American.
 
cuemaker03 said:
Where can I buy the tap for 3/8-14?
Click to expand...

I could be wrong but actually I believe that the Cue-tec pin is a slight bit smaller than a 3/8 X 14 tpi. I have a 3/8 X 14 tpi. tap and it makes for a sloppy fit when making a brass insert for a Cue-tec. Of coarse Cue-tec uses a plastic type of insert that will close up slightly after being tapped and this may be the difference.
Dick
 
rhncue said:
I could be wrong but actually I believe that the Cue-tec pin is a slight bit smaller than a 3/8 X 14 tpi. I have a 3/8 X 14 tpi. tap and it makes for a sloppy fit when making a brass insert for a Cue-tec. Of coarse Cue-tec uses a plastic type of insert that will close up slightly after being tapped and this may be the difference.
Dick
Click to expand...

You are correct, I have one I designed specifically for cuetec's and I have two for the Bender and Omega's.
 
Cue-tech...3/8-10?

jazzn4444 said:
Cuetec uses 3/8-10. you should be able to get that at Atlas, no worries.
Click to expand...

I just bought joint protectors for a customer that has a Cuetec and the package clearly stated 3/8-14.
By the way...Creative inventions sells the driver set for $19.99. Hope that helps.
Gene
 
You must log in or register to reply here.
Back
Top