wtb: 5/16-14, non-piloted (flat-faced) joint

Aristo

Aristo

Sneaky pete freak
Silver Member
Looking for a 5/16-14, non-piloted (flat-faced) joint shaft to fit my jacoby cue. Something with a nice taper, preferably smaller than a 13mm. Not looking to spend too much, but if you do have any, drop me a PM or post on here, i'll be sure to check.
 
okay another quick bump, anyone have a "used" jacoby shaft? cant spend too much.
 
Get a nice pilted shaft

Have a builder cue the pilot off and face the thing. Should be about $30 for the work.
Nick :)
 
thanks for the tip, but i think id rather just buy a used jacoby shaft that'll fit perfectly onto mine. Thanks though.

anyone out there with a used jacoby 5/16-14?
 
a jacoby branded shaft wont necisarrily fit perfectly either....
i'm having a similar issue with a joss i have. it has an extrodinaily larg joint at .865" and most ob1/predator whatever shafts are around .85" along with all the joss branded shafts i've tried as well. if you want somethign to fit perfectly, you'd be best off having one customer fitted, but then it wouldnt be cheap. here some branded extra shafts avaiable here, some arnt too bad, just got to dig through to find which ones have 5/16x14 flat face...

http://www.pooldawg.com/category/extra-pool-cue-shafts
 
You must log in or register to reply here.
Back
Top