WTB - Gulyassy OB1 Shaft

[Mike Templeton]

Does anyone have an OB1 with the Gulyassy 3/8-10 Acme thread joint size? I'd like to try an OB, but I don't think one is available with the special thread size that Gulyassy uses.

I'd like to consider trading my Tiger Ultra shaft for it. Here is a link where I tried to sell the Tiger shaft a month or so ago.

http://forums.azbilliards.com/showthread.php?t=121178&highlight=tiger

Thanks for any help.

Mike

 

[Stan9]

I had one but sold it. It has the same thread as my other 3/8x10 shafts? I remember trying it on other cues i had and it fitted just fine. The only difference is that the taper is extra long - it's something like an 18-20" straight taper.

 

[Mike Templeton]

Thanks Stan,

I tried to screw an OB1 yesterday with a regular 3/8-10 thread onto my Gulyassy butt, and it wouldn't fit. I'll check with Mike G if nobody here has anything, but I was hoping to be able to trade a little something first, and I would also like to get something used to be sure i like it.

Thanks Again,
Mike