I'm looking to sell this cue, but would consider trading the cue for another custom wrapless only. When I say custom wrapless, I mean custom cue makers like Joe Gold, Ed Young, Carmeli, Gilbert, Cohen, Manzino, Bender, Barnhart, etc etc. Please don't offer up a Jacoby cue, or a Predator, or anything remotely close to a production cue. Just don't.
Cue is constructed of Afrazaleia Burl in the butt, handle, and forearm, and has super nice graining, very very clean. The points are ebony, surrounded by quad bridged veneers. The inlays used are made from Paua shell, very nice coloring and sheen to them. All the white is ivory: rings and joint. Two original maple shafts included, both of which have ivory ferrules. There's also a third shaft, a Diveney kielwood shaft, that has matching ringwork. Cue butt and original shafts have matching custom joint protectors.
Cue is in great shape. The butt rolls straight on a lathe, the shafts roll straight on a lathe. Very little use on the shafts, and the butt is damn near perfect, with the exception of one small scuff on the butt cap.
Butt: 29", 15.5oz, radial G-10 pin
Shaft 1: 29", 3.8oz, 13.10mm, Ivory ferrule, Moori tip
Shaft 2: 29", 3.5oz, 12.90mm, Ivory ferrule, Triangle tip
Shaft 3 (Kielwood): 29", 3.7oz, 13.10mm
SOLD, PENDING SALE
If you'd like to trade, I'd like to keep the value as close as possible between trades, and unless it's a killer cue, I'm not really wanting to put up any more cash than I already have into this one.
For quickest response text me at 773-655-8697, or leave a message here on this thread, and then PM me.
Cue is constructed of Afrazaleia Burl in the butt, handle, and forearm, and has super nice graining, very very clean. The points are ebony, surrounded by quad bridged veneers. The inlays used are made from Paua shell, very nice coloring and sheen to them. All the white is ivory: rings and joint. Two original maple shafts included, both of which have ivory ferrules. There's also a third shaft, a Diveney kielwood shaft, that has matching ringwork. Cue butt and original shafts have matching custom joint protectors.
Cue is in great shape. The butt rolls straight on a lathe, the shafts roll straight on a lathe. Very little use on the shafts, and the butt is damn near perfect, with the exception of one small scuff on the butt cap.
Butt: 29", 15.5oz, radial G-10 pin
Shaft 1: 29", 3.8oz, 13.10mm, Ivory ferrule, Moori tip
Shaft 2: 29", 3.5oz, 12.90mm, Ivory ferrule, Triangle tip
Shaft 3 (Kielwood): 29", 3.7oz, 13.10mm
SOLD, PENDING SALE
If you'd like to trade, I'd like to keep the value as close as possible between trades, and unless it's a killer cue, I'm not really wanting to put up any more cash than I already have into this one.
For quickest response text me at 773-655-8697, or leave a message here on this thread, and then PM me.
Last edited: