FS: Dan Janes Sneaky and Instroke 2x4

PROG8R

PROG8R

Gator Nation
Silver Member
Here is a JOSS. I picked this up on here about 7 years ago. It is a Sneaky that came out of Dan Janes shop. I do not have calipers and I do not know the size of the shaft. I believe it is just under 13.
I have an email from him about it. I will post it under this add for clarification.
This is not one of those collectors cues that just sit around. This has been my player and I love her, but I have not been playing much at all for the last year or so. She has a 2-3 small nics only in the finish near the butt. I Just had the shaft cleaned and a Kamui Clear soft put on it about 3 weeks ago. It has a radial pin and man does she feel amazing.
Changing directions in life and this has to go.
$220 shipped in a 1x1 case for protection:
cue.jpg
 

Attachments

  • collage1.jpg
    collage1.jpg
    97.2 KB · Views: 1,177
  • collage 2.jpg
    collage 2.jpg
    96.2 KB · Views: 1,127
Last edited:
Jon,
This is one of my cues. I made it for Mike Webb. Mike is a top cue maker and needed a cue right away for a friend.
This cue was made by myself and my son and was finished completely in our shop.
It would have taken him longer than he had to make this cue so I sent him the SP I had. I didn't put the logo on just because of time.

Regards,
Dan
Joss Cues Ltd.
 
PROG8R said:
Jon,
This is one of my cues. I made it for Mike Webb. Mike is a top cue maker and needed a cue right away for a friend.
This cue was made by myself and my son and was finished completely in our shop.
It would have taken him longer than he had to make this cue so I sent him the SP I had. I didn't put the logo on just because of time.

Regards,
Dan
Joss Cues Ltd.
Click to expand...

I think I know the story behind this. I may be wrong about this being THAT particular cue, but if this is the cue, it's a funny story. A friend of mine had a cue that was being worked on by Mike, he was cleaning it up or doing something with the shaft or tip. He had it on the lathe and was talking to the guy while working. One of the tools was getting a bit close to the cue, Mike did not notice it, till... zzzzzzshhhht, it cut into the cue and made a nice mess.

Mike called up Joss and had them make a new replacement cue for the guy right there. I am thinking that there were not that many cues that Dan made for Mike Webb, so this is probably that cue.
 
Last edited:
hang-the-9 said:
I think I know the story behind this. I may be wrong about this being THAT particular cue, but if this is the cue, it's a funny story. A friend of mine had a cue that was being worked on by Mike, he was cleaning it up or doing something with the shaft or tip. He had it on the lathe and was talking to the guy while working. One of the tools was getting a bit close to the cue, Mike did not notice it, till... zzzzzzshhhht, it cut into the cue and made a nice mess.

Mike called up Joss and had them make a new replacement cue for the guy right there. I am thinking that there were not that many cues that Dan made for Mike Webb, so this is probably that cue.
Click to expand...

This was made by Dan for Mike.
 
You must log in or register to reply here.
Back
Top