Did anyone notice that this is not a digital indicator?
Sorry Lee, just had to point that out.
Sorry Lee, just had to point that out.
What is "acceptable" T.I.R. ??
- Thread starter Dirtbmw20
- Start date
LOL, thanks Frank. I don't type worth a crap. I wondered when someone was going to mis-read what I wrote.
I said I have a digital indicator that I originally used before but the pic was taken with my "mechanical" indicator.
Sent from my SCH-I535
At work I am now one of the old school toolmakers. The new guys have all this digital stuff.
But when trying to dial in a job to be better than 0.01mm the 0.01 resolution DTI just is not good enough.
The cost of the 1 um stuff is too much for them. The next best is digital transducer, but I like the dial on these as well instead of the digital counter.
When clocking in a 4 jaw, I like to use 2 keys, one each side. Makes it quite quick to dial in, especially if you only need 0.02mm.
But when trying to dial in a job to be better than 0.01mm the 0.01 resolution DTI just is not good enough.
The cost of the 1 um stuff is too much for them. The next best is digital transducer, but I like the dial on these as well instead of the digital counter.
When clocking in a 4 jaw, I like to use 2 keys, one each side. Makes it quite quick to dial in, especially if you only need 0.02mm.