does the base and slate on my GCIII have a head and foot or can i install either way? there is a penciled "H" on one end and i'm assuming that means the "head" of the table but i can't see any difference between the ends.
also: i'm really angry with myself for hurrying and chipping the foot slate when i took this table apart. i looked at it in detail yesterday and it's much worse than just a small chip out of the top. the cracks go down into the pin holes. before i screwed it up, the slate was PERFECT but now, not. i almost smashed it with a sledge and still might do that if i can't get my anger under control. i drove 400 miles round-trip to get this table. i'm severely depressed about it. i've been looking for an 8' GC for YEARS and finally found one and then promptly destroyed the slate.
also: i'm really angry with myself for hurrying and chipping the foot slate when i took this table apart. i looked at it in detail yesterday and it's much worse than just a small chip out of the top. the cracks go down into the pin holes. before i screwed it up, the slate was PERFECT but now, not. i almost smashed it with a sledge and still might do that if i can't get my anger under control. i drove 400 miles round-trip to get this table. i'm severely depressed about it. i've been looking for an 8' GC for YEARS and finally found one and then promptly destroyed the slate.
Attachments
Last edited: