Anyone have this ring work?

[bowiebill]

Looking for this ring work

 

[CocoboloCowboy]

Think this is not complicated to do, many Cuemakers could duplicate.

 

[Michael Webb]

Looking for this ring work

Info needed.
How many slots?
How wide is the maple?
How wide is the black?
How thick is the billet?
How thick are the other rings that make the stack?

 

[bowiebill]

Info needed.
How many slots?
How wide is the maple?
How wide is the black?
How thick is the billet?
How thick are the other rings that make the stack?

18 dashes that are 2.8 x 1.4mm best I can measure

each silver ring is about 1mm
black between silver and dashes is all 1mm and the thick black at top and bottom is 3.25mm
entire “stack” is 12.8 mm

 

[bowiebill]

Joint is .845”

 

[bowiebill]

My math doesn’t add up. Will have to try to measure it all again. Uggg

 

[bowiebill]

Struggling to measure this, but closest I can seem to get is…

whole stack 13.8mm
Silver rings and black between silver and dashes is about .75mm
Black on shaft side is 2.8mm
Black at the joint is 3.6 mm
Dashes still look like 1.4 x 2.8 mm

 

[aphelps1]

I'll make a couple for you.

Alan

 

[Sheldon]

If you get a better picture, this can be handy: https://eleif.net/photo_measure.html

 

[bowiebill]

If you get a better picture, this can be handy: https://eleif.net/photo_measure.html

That looks correct. What should I do better about the picture?

 

[Sheldon]

That looks correct. What should I do better about the picture?

Use a background that contrasts more, and make sure you are not at any kind of an angle.

 

[bowiebill]

Use a background that contrasts more, and make sure you are not at any kind of an angle.

 

[Sheldon]

Needs more focus. Crisp edges will get you much better measurements.