Yes sir
If it is the asian version and you know anyone with a 3/8x8 tap. Even a standard 3/8x8 tap. Then the shaft will fit both the Radial and the 3/8x8.
3/8 spiral joint?
- Thread starter NathanDetroit
- Start date
If it is the asian version and you know anyone with a 3/8x8 tap. Even a standard 3/8x8 tap. Then the shaft will fit both the Radial and the 3/8x8.
Thanks Michael, appreciate that
I think a better picture from the seller is REQUIRED before purchasing....Nowadays someone has to work hard to fk up a picture that badly. It could be a 3/8x10 modifided, but the pic is to blurry to tell. Ask for a clear picture with a ruler alongside the pin butted up against the jointfacing....only real way to tell....everything else is just guessing....if the seller refuses....move on down the line....IMHO
Any idea where I might find one, or maybe a cue maker that can tap it to a 3/8-8?
Schmelke use to sell one for the 3/8x8 ball screw. Better to find out what you actually have first.
Ask your Cue maker if you have one near you.
I'm pretty sure it's 3/8-8, according to scale-8 tpi.
I'm not sure what the radial tpi is, but the radial shaft doesn't fit.
Even if it was a clear picture, it would be almost impossible to tell the difference between an actual radial screw or the 3/8x8 ball screw.
I searched the forums and found a few saying their 5280. Replys noted there is an import that will not accept a standard (US?) radial.
Thanks
Thanks
Can a standard radial shaft be tapped to fit a 3/8-10 pin, without plugging the shaft?
People are doing it but they shouldn't be. One time cross threaded and it tears the threads. Do it correctly and be done with it.