Cuetec pin

j2pac

Marital Slow Learner.
Staff member
Moderator
Gold Member
Silver Member
Would anyone happen to know if Cuetec has always used a 14tpi thread? I would also like to know if their joint diameter has changed any over the years? My thanks in advance for any help/information.
😎
 
Would anyone happen to know if Cuetec has always used a 14tpi thread? I would also like to know if their joint diameter has changed any over the years? My thanks in advance for any help/information.
😎
Same joint screw.
Joints are approximately
.790 and .838
All the new one's with a Cynergy shaft are .838
 
I just did a few shafts for older Cuetec cues and I used my standard minor and that seemed to work fine. These cues must have been from the early 2000's
 
Back
Top