WTB - Kielwood shaft to fit 3/x11 pin

[RandyinHawaii]

I have an Omen Cue that I would like to try with a kielwood shaft. Joint diameter of butt is approximately .836". Shaft joint doesn't have to be exactly that diameter, but would like it close.

If you have one that you would sell, please let me know maker, specs and conditions.

Scammers, please don't waste my time and it will be a waste of your time!

Thanks

 

[David in FL]

I have an Omen Cue that I would like to try with a kielwood shaft. Joint diameter of butt is approximately .836". Shaft joint doesn't have to be exactly that diameter, but would like it close.

If you have one that you would sell, please let me know maker, specs and conditions.

Scammers, please don't waste my time and it will be a waste of your time!

Thanks

Reach out to Richard Hsu and be done with it...

 

[RandyinHawaii]

Reach out to Richard Hsu and be done with it...

Thanks and just submitted order.

Still looking for a used one to use until the one I ordered arrives.

 

[KenneyTran]

I have a 30” Tsunami 2.0 but it’s cog pin. I will have another cog on the way so I might keep it to fit it.

 

[RandyinHawaii]

I have a 30” Tsunami 2.0 but it’s cog pin. I will have another cog on the way so I might keep it to fit it.

Thanks for response. Think I may have found a shaft that will tide me over until I get Hsu shaft.