aphelps1's latest activity

  • aphelps1
    aphelps1 replied to the thread Cuecut.
    I sent you a PM
  • aphelps1
    aphelps1 replied to the thread Cuecut.
    Cue Mill is 1.24 and Cue Lathe is 1.23 on my system. I think that was the last update.
  • aphelps1
    aphelps1 replied to the thread Gun drill?.
    If you are going to make cored cues, there is no good substitute for a good gun drill. I have several sizes depending on what I'm...
  • aphelps1
    aphelps1 reacted to JoeyInCali's post in the thread Uniloc joint straightness with Like Like.
    Both. No.
  • aphelps1
    aphelps1 reacted to Sheldon's post in the thread Tip installed up side down with Like Like.
    In my experience, no. There are some tips where the layers are slightly different by design, but most of them are consistent and can be...
  • aphelps1
    aphelps1 reacted to BarenbruggeCues's post in the thread N with Like Like.
    Even blasting air full bore you'll probably create more heat with more chance of deteriorating the glue bond at the points using a gun...
Show older items
Back
Top