Recent content by eddie8842

They make a new one with black collar silver ring, not that one I'm looking for the no collar version Thanks

Updated

Replied to all PMs, updated list

Offers welcome

Pm sent

None of those

It's probably around $5k worth of DVDs cause a lot are impossible to find I'm asking $2k shipped CONUS I'm willing to split them up though, so make some offers on individual ones or multiples I'll adjust the list as they get sold. Killer one pocket cliff Joyner SOLD Willie joplings 1P and...

That looks like it's worth a try, thank you very much

😂 You said it

That would've been a lot easier, could've just thrown one of these in there and been done with it

It's approximately m22x2.0 And my fabrication capabilities are non existent at this point, been mostly working with taps and dies, knives and glue for tip repair work, sold my lathe a few years ago but it's wasn't that capable anyway

So, I'm not quite sure where to go from here. Couldn't really tell before but it already had this plastic threaded piece, and in trying to tap it, it came out and was so thin it cracked, so I just took out the ridiculous 4oz weight bolt too, odd size 7/16-14 Any ideas? I'm guessing send it off...

Here's hoping I don't mess it up too bad haha, although all I'm really after is function

Oh ok, got it, and thank you for that clarification, I definitely misunderstood the first comment

It's about 18.5mm, should fit the m20 well. I'll try it and hope it's not an acetal, fingers crossed. I appreciate your advice. Thank you.