epoxypop's latest activity

Why not core it or have it cored? If you stabilize it, you may have to core anyways, it will gain a bit of weight

Sand the ferrule , sand the tip, then wick the tip before gluing it on. You will have no problem with loctite, starbond or any other ca,

. Most super glues work if prepping is done properly

I'm not absolutely positive however i think the 3/8-11 modified is .3125 Mike Webb will know for sure

Stickers are easy. Print your own at home or order custom stickers from a variety of sources. Durt cheap. Waterslides too. Some will...

I installed this in a mockup . i cut it off before it was glued Impossible to remove , my easy out said no.So any rate when i tried to...

I can tell you who sells those stickers Hey guys this guy is brand new be careful.

the .550" cap is so when done, you don't see a spiral from the threads. It's a full circle. if doing a fully threaded plug, it will look...

I like those no threads just a glue relief. Are you using west system on those I do use Bob Sitith slow cure on most?

I'm sure we are both using the same index cutter, i may have just been going a little to fast. i don't see any reason for that cap...

I do the same. i was just curious how Huebler could have threaded those uninstalled. Seems like it would have been a lengthy process...

I have to ask, what did you cut the .550 head off with? Maybe, my speed or feed were too fast it got hot and hard to get a nice clean...

Let me ask, are you sanding a one piece cue by hand, not in a lathe? I hope not

Try shellac on a small area see if it works if you keep sanding you may end up with a tooth pick, so to say Your white specks are what...

Yes, the guy who removed the aluminum Huebler weight bolt said he drilled a hole in it for more contact area and used a soldering iron...