on original factory cushions that are in good condition they all play like GC’s….older ones with new cushions w/o subrail mods play short and hop or pinch if the mechanic wasn’t very careful
You ever play on an early 3 or before that had the newer width superspeeds? Without the sub rails...
Calibration and instrumentation is the broadest trade on earth….to set up and install anything to result in a very specific repeatable action or reaction to any force that can be sensed or incurred by the machine, material or tool is 100% calibration.
at the end of the day that cushion is in...
I don’t have issues with my eyes wanting to veer being that I use them together…yet reference with “parts” of them individually….
hal had center to edge in regards to the cb/ob
I superimpose the shaft over the cb and the center of the shaft or one of its edges will be in line with my ob...
Yes I’ve done this for ohhh closing in on 20 years. I air pivot from the stand up and have my eyes locked into the shafts line there al the way down dropping into setting at the position at the cb (English or not)
the most deviance ill show is nose left or right of the shaft for some cuts...
Contract work has ZERO to do with a contractors license.
A contractors license is needed for INSTALLERS
If your a cabinet maker and build a person 100k dollars worth of cabinets, but the installation is done by someone else….you do not need a contractors license but that installer will...
He was…thanks for bringing up the thread, he hadn’t crossed my mind in some time, I don’t come on here too often anymore so it brings back good memories!
Man I love y’all but every time someone says Tulsa/Oklahoma is humid I lmfao. I remember piggy banks crying saying thaf playing David Strawn 20 years ago and I laughed then about it.
I am of course from south Louisiana so I’m def cynical about that lol….tho oddly enough my table offshore...