Recent content by j2pac
-
314-3 vs Vantage shaft
If that is your goal, the Vantage might just be what you are looking for. Good luck with your search.- j2pac
- Post #18
- Forum: Main Forum
-
314-3 vs Vantage shaft
Never played the Z, but the V felt far too "stiff" for my liking.- j2pac
- Post #17
- Forum: Main Forum
-
-
Thoroughbred vs Searing precision
The Thoroughbred Medium Soft is one of my favorite tips. I've recommended them to several folks without disappointment. 👍- j2pac
- Post #12
- Forum: Cue Accessory reviews
-
Warped maple??
If you have the ability, coring might help ease your mind as well.- j2pac
- Post #11
- Forum: Ask The Cuemaker
-
Warped maple??
The 15mm triangles are the trick, to the best of my knowledge. Decent Triangles are as good as anything out there IMO.- j2pac
- Post #10
- Forum: Ask The Cuemaker
-
-
To my knowledge, NPR is not gone. You have to login to see that particular forum.
To my knowledge, NPR is not gone. You have to login to see that particular forum.- j2pac
- Profile post comment
-
-
WTB Butt only to fit 3/8 14 Cuetec Shaft
Which joint size? Legacy or newer? -
In the very first post, you left me an angry emoji. Just trying to figure out if it was a "butt...
In the very first post, you left me an angry emoji. Just trying to figure out if it was a "butt dial." 😉👍- j2pac
- Profile post comment
-
Why the angry emoji over the pt109 post/thread?
Why the angry emoji over the pt109 post/thread?- j2pac
- Profile post
-
Kancha Bhowmik Your cues are ready..
Another outstanding execution.- j2pac
- Post #3
- Forum: Cue & Case Gallery
-
Project Tomahawk ferrule material.
New year. Same kick arse material! 😎☝️ ☝️- j2pac
- Post #573
- Forum: Cue Machinery and Supplies
-
HAPPY NEW YEAR AZers!!!
- j2pac
- Post #5
- Forum: Main Forum