Recent content by joe pizzuto

Glen Hancock and Rich Geiler should be o k thanks for advice

Thanks to Doug and Glen. They put me on the right path.

I have a brunswick gold crown table. First edition i think. recently, I had it recovered and new cushions. they needed to be cut sharp. The job turned out beautiful, but , like it always has, spits out more balls than it should. The guy says it always will. That is not true, . So i need someone...

I am Joe, Johns brother. (Not so little) I asked him to post my pictures , since I can't figure it out yet. the table turned out really nice. Thanks to all concerned. The pockets are 4 5/8 . And honestly, the pockets are receptive to a reasonably good shot, unlike before. To Chip, I...

what photo are you looking at? The first photo I sent my brother is the one that two balls will not pass and it has never been altered. joe

proper observation, thanks

touche!

Sir , you are the one who is the most correct after seeing the rail, facing , old rubber, and wood facing at the throat. New rubber and new facing will fix this. Thanks to all who wrote in. I will put a picture up when it's done

it is a model 6100, gold crown 1, unmodified and 2 balls do not pass. Where do these guys get their info? joe

It has never been modified. This is pure wear. The wood is perfect. New sharply cut rubber and 6.4 mm pads and it should be good. They say ( the pad manufacturer ) that should tighten it up to 4 3/4. I'll be happy. He will take a week to get the cloth. Thanks to everyone who showed interest in...

I own the God Crown 1 that everyone is so helpful with. I have secured a pool table guy who could do that work if it really needed it, or if I insisted. I saw the raw wood and it is in perfect shape. The end pad was hammered out of shape as well as the end of the cut on the cushion. All he...