Recent content by Lp20

pretty niffty.

I will try to get more pics up tomorrow. Thanks for all the nice comments. I'm very lucky to have been in the right place at the right time to select this piece of wood. Oh! and friends with a hell of a cue maker. It is realy a screw up. The resin did not penatrate all the wood. That is why I...

Blue Resin Impregnated Redwood Burl. Red Palm Sectional Handle. White Micarta Ring with Abalone Dots. 300 Year Old Maple High Growth Shaft. Shaft made from 1 inch floor boards salvaged from NY office building built in 1802. TR Custom Cues are made in the Mountains of SW Virginia for the past 10...

I have been using a PH Break Jump cue for about 3 years. Yes you can hit the crap out of the balls, but it is not always productive. It's nice to get all the ball to scatter all over the table, but if you don't a ball. It a great break for the other goy you are playing. What I have found is I...

Tom Reed of South West Virginia. Great Playing cues.

Who is playing today. It's all in my head. When you’re on your on and when you’re not, man it can for a long night. I have a confidents problem, so I go back and for. I also for some reason, without knowing start playing like my opponent, or whoever I practice with. ** What’s up with that? **...

Thanks Chris for the info. Jeff

Thanks for your answers. I knew leaving it alone was the best bet. Yes shafts are not originial, but I love the way they hit. They came with the cue. I play with the 12.5 shaft, but the 13 doesn't even look like it has been touched. I just wish I could figure out the year and how many were made...

The butt on this cue has been refinished because there is finish on the butt cap. I understand that schon will replace the butt cap on refinishing Jobs. The foraem is in perfect condition. New wrap would be nice. The butt has a nick/gouge below wrap. I have 4 options I think. 1-Send back to...

PM Sent Jeff

Thanks Gary. I was looking at the prisition bits site. Thank you all. I should be on my way. Jeff

Thanks, Ill call him in the morning. Jeff

I have been helping out a local cue maker and we would like to find; .020 & .025 dia. bits with about .062 shank. To fit a Dremel Tool. Any help on finding these bits would be great. Thanks, Jeff

Mine needs new finish I have the same model that needs a new finish job on it. I agree that it is a 1993 model. That pin seams to be an indication of a 93. I have seen 3 or 4 and never could fine anything about them. I even e-mailed Evan, but no answer. Mine came with a shaft like yours, Most...

Nice Cue. If I did not just get an R-12 Red and Blue, I would consider this. With the time the way there are, it seems prices have fallen a little. Good Luck with the sale. I bet it plays like a monster. Jeff