Recent content by rackcracker

Good morning everyone.

Good morning everybody.

For the night folks.

All PM's answered.

Thanks for the intrest. The shafts vary in weight by nearly an oz. so the weight bolts will vary as well. If you will let me know what weight, and balance point you prefer I will do my best to accommodate you. I will pm you the specifics. I have seen a few weight bolts as heavy as 35gram, I have...

Good morning everyone. http://imgur.com/a/QjztiHope this works for the pics, Thanks to a fellow az'er for helping out.

Afternoon Folks.

Getting dark.

Good morning everyone.

evning folks.

Good morning everyone. When I tried to post pics I am asked for a url. I have pics on my computer, not on the internet. If anyone can help me through this dilema I would appreciate it.

Here we go again.

Rosewood spliced into Birdseye Maple, with black and green veneers. Full splice butt(points in each direction). Rock hard maple shaft, short (12mm) ferrule, 12.5 mm diameter layered tip. Straight cone Eropean taper, about 22mm at the joint collar, 57.5 inchs long from tip's tip to bumper's end...

Nevermind, The link Travis posted is what I was looking for. I am very intrested in this topic as well. My current table is an older cheaper brunswick with century U56 cushions, no subrails, glued straight to the partical board. This profile inherntly tends to trap the ball slighly, making it...

According to the seller the laminate included is correct for the table, bought at a billiard supply place. I don't know what they call it, but if it is it's pretty durable. I have seen numerous cues, long necks (lot of them didn't break) broken over rails, cigarettes burnt down, didn't even...