Recent content by RocketQ

holders At the expo we use two plastic laundry baskets one for the base and a second one cut in half stuck in sideways so the holes face up. Holds enough for a full rolling days work.

Taper The joint size would be the bigger hurdle. Most builders are set up for a specific joint diameter and don't vary at the joint.

merry widow I have done a few out of other woods. I don't have a piece of the wood you are looking for so with that said it will be quite a long time to cut to ensure it stays straight.

Thank You Thanks for the review Stephan. Which shaft did you like better heads or tails? The sleeve was a definite challenge to figure out but in the end it turned out great. It was a pleasure to work with you and I look foreword to any future opportunity. Good luck in any future tournaments...

tips Tiger dynamite and water buffalo black.

Dings OK so the first thing you did wrong is used a buffer. The only thing the glass rod did was crush the surrounding wood fibers to the same level as the ding. Now with that said you may have ruined the shaft. Depending on how deep the ding was. Without having the shaft in front of my I...

I have the correct tap. I fix a bunch of these from incompetent repair guys forcing the wrong pin in to drive the shaft. The 3/8-11.5 tap you can buy is not even close to the right tap.

I have a similar one. Built very close to the same way. Give me a call. 724-331-6649 John

Cap an LBM and it probably will never happen again. Juma has no binder in it to resist splitting. It is a thermoset plastic material. John

good event This is always a good event. I have been going for 6 years and it gets better every year. Good players good action good people and most of all a good cause. Plan on being there again this year. John

If you run into a problem where the tool wants to walk all over the place try loading the tool box slides. What I mean is bump the mounts either in or out to add tension or compression to the plate. This will help to take the slop out where you have 2 slides. Rigidity is the key to any...

copper I have been using copper for about 7 years. And as far as metal rings in a cue it is mainly all I use. You just have to know what to put next to it to set it off. John

Machine Machine still available.

pics If I had your email address you got an email. Dave I will see what I can get done. I will give you a call later on. John

I have a manual inlay machine similar to what Hightower sells. This machine was built by Barringer. Then tore apart, rebuilt and upgraded by me. I am asking 1400 + shipping. Dremel spindle thompson rods and bearings misc pilots inlay templates If you want pictures I will email them. I can...