Recent content by TomWadsworth

  1. T

    Oak Titlist conversion,Old Adam Cue, Several LD shafts

    Last price drop on the Titlist. $500 shipped. If it doesn't sell at this price I'm keeping it. I just would rather have money than the cue is the only reason I am selling it. The shafts on the other hand need to go. I have no use for them. Send me a REASONABLE offer on the shafts and we might be...
  2. T

    Oak Titlist conversion,Old Adam Cue, Several LD shafts

    Well it seems you have to give stuff away for it to sell these days. So here are give away prices. #1 Oak Titlist $550 you will never find an oak titlist cheaper ever! #2 Adam Sold #3 Skinny Z2 $75 #4 Radial Z2 $110 Stupid low price for a Predator Z2 #5 CDX 30" 11.75 $100 If you have wanted to...
  3. T

    Oak Titlist conversion,Old Adam Cue, Several LD shafts

    I will be honest and say I like the Z2 better but I think that the CDX shoots just fine. I just don't like the 30" shaft. I didn't think the extra inch would bother me but I just can't get used to it.
  4. T

    Oak Titlist conversion,Old Adam Cue, Several LD shafts

    #1 Todd Schaller oak Titlist conversion Around 19.5 oz, 3/8x10 pin, 13mm shaft Cue has a roll. Looks like a slight lift in the joint. Never bothered me. Shaft has a taper roll. I'm going to try to include a video of me rolling this cue if I can't get it uploaded here I can email it to you. A few...
  5. T

    Brunswick Gold Crown 3 Replacement Cushion questions

    I recently purchased a Gold Crown 3 9ft table. I doubt the cushions have ever been replaced. I can hear and feel dead spots when a ball hits certain spots. It also has champion cloth that is the opposite of simonis. It rolls fine but it is much shaggier than simonis and little puffs of cloth are...
  6. T

    Sugar tree, cocobolo and curly olive wood.

    One of my favorite Sugartree cues of all time. Wish I had the dough. GLWS
  7. T

    3/8x10 modified pin question

    I have an old Mcdermott D4 with the standard 3/8 x 10 and I have an Oak Titlist conversion with a modified 3/8 x 10 and I use a predator z2 shaft. My predator shaft screws on to either cue with no problems.
  8. T

    Brunswick Gold Crown IV, drop pocket FS

    PM sent. Thanks
  9. T

    FS Scott Whisler Titlist conversion and several LD shafts

    Bump. Will trade for a Predator P3 or a Predator Willie Hoppe with Z2 shaft.
  10. T

    FS Scott Whisler Titlist conversion and several LD shafts

    The shaft are sold. This is the last week I am going to attempt to sell the cue. Then I am going to get it fixed and keep it. Get it while you can. If you want a really nice Titlist conversion for a good price here it is. The sleeved Ivory joint will only run you 150-200 max to fix. You will...
  11. T

    FS Scott Whisler Titlist conversion and several LD shafts

    Last day the shafts will be available. The ebay auction ends tomorrow. $150 shipped each. I will trade the cue to a Predator P3 with a Z2 shaft up/down/even depending on which P3 and condition.
  12. T

    When is a Foul a Foul?

    A foul is a foul when you foul. Anytime I foul I call myself out and give ball in hand to my opponent. Unfortunately most people don't do that these days.
Back
Top