Can anyone ID this ringwork?

[jlrowe]

Got this shaft off ebay few months ago. Guy didnt realize it was a Predator partial. Got it cheap. Cleaned it up and looks great . I know i have seen this ringwork before and Jay Helfert had a regular shaft with this ringwork. Im was thinking it may be for a Meucci due to the joint diameter of .820 5/16x18 flat face.

 

[DeeDeeCues]

That is definitely Cubby Ennywon ring work.

 

[garczar]

That is definitely Cubby Ennywon ring work.

niiiiiiiiiiiiiiiiiice

 

[cueman]

What is the insert made out of?

 

[Chopdoc]

Similar to McDermott D-21 but not the same.

 

[jlrowe]

What is the insert made out of?

Hey Chris Thanks, The insert is brass. Had to go back and look but when i got the shaft it was a 5/16x14 and i tapped it to 18 to use on a Meucci Original. So it had to be a cuemaker that used 5/16x14 none pilot with a small diameter joint .822 diameter.

 

[cueman]

If 14 thread original flat faced it would be a smaller cuemaker and no production one I know if.