Search results

Hi Kelly - I have two drive boxes that are both parallel. One has been converted to USB and the other uses Ethernet smooth stepper. The USB box works good, however, occasionally it loses connection when switching from incremental and continuous modes. I've never lost a connection during a job...

I can do it. I charge $50 a shaft + shipping Sent from my Pixel 4 XL using Tapatalk

The pin length looks fine to me. I would say the shaft wasn't threaded deep enough. Sent from my Pixel 4 XL using Tapatalk

http://cueveneer.com/ocart2/Cuebuilding-with-dyed-veneers/mitered-veneers You can use painters tape or I created a jig out of aluminum with 90 degree inside corner. Line jig with wax paper and use surgical tubing as a clamp until the glue dries. Phil Sent from my Pixel 4 XL using Tapatalk

In that case, black spray paint will work. Apply 3-4 light coats, then wetsand with 600/800/1000. I've painted entire carbon fiber shafts white for a customer using this method. To remove, just use acetone. Phil Sent from my Pixel 4 XL using Tapatalk

You can paint it and seal it with some super glue, however why not just have the ferrule replaced with black juma? Sent from my Pixel 4 XL using Tapatalk

I use fusion 360 Sent from my Pixel 4 XL using Tapatalk

I'll take 4 Sent from my Pixel 4 XL using Tapatalk

PayPal sent. Thx Sent from my Pixel 4 XL using Tapatalk

I'm right around 118-120 after a few hours Sent from my Pixel 4 XL using Tapatalk

http://www.midamericapool.com/parts---accessories.html Sent from my Pixel 4 XL using Tapatalk

My machine was modeled after JCs tapering setup. The reason the vertical mount appeals to me is it saves floor space and the chips fall down due to gravity :-) Sent from my Pixel 4 XL using Tapatalk

CNC tapering machine fully enclosed Sent from my Pixel 4 XL using Tapatalk

It's what the customer prefers Sent from my Pixel 4 XL using Tapatalk

How much does predator want for 10? I've tried in the past and they wouldn't even sell me 1 lol Sent from my Pixel 4 XL using Tapatalk

Thanks! I also see you've mounted an scale to your carriage.....do you have any more pics or information on that? -Phil

Thanks for the information! I might just go ahead and do the same and get a mount from Todd. Sent from my Pixel 4 XL using Tapatalk

Can you measure the thickness of the riser? I want to make one. Also, how is the stud mounted to the rise? Tapped? Thx, Phil

I can do it. I've done several. Sent from my Pixel 4 XL using Tapatalk

I've replaced many Mezz ferrules and I always eliminate the gap Sent from my Pixel 4 XL using Tapatalk