Search results

Thanks but that wasn’t the issue. The sides of the bumper had enough clearance. The issue was not being able to tighten without the bottom of the bumper squeezing out leaving it too loose.

The pin is discussed in the thread below. Do not know if a regular Radial joint protector would work. Thread 'Evan Clarke with Segen Cues' https://forums.azbilliards.com/threads/evan-clarke-with-segen-cues.401389/

Thanks and yes I do know about the hex. One of the first problems I had was the metal doesn’t touch the cue first, the bottom of the bumper does. When I tighten it down the bottom of the rubber would squirt out from being pinched between the cue and the metal. I tried to solve it with a washer a...

Finally pulled the trigger on a gun drill a couple weeks ago so I can start coring my wood. Should get it in a couple of weeks. I did get another smaller gun drill for a good price used. (Thanks J.C.) Been wanting to try making an extension for my cue and thought it could be a good test for the...

I just made my first extension. Took it out for a test run last night and had an issue. Put it on and off a couple of times and then the bumper unscrewed out of the cue instead of the extension out of the bumper. The friction of the rubber is gripping more than the bumper threads in the wood of...

Perfect timing. Waiting for my car to get serviced. Unlike half the other people here I can watch it without annoying others around me. Fantastic cue. Love to watch these.

Here is a link to a trailer. This was not https://www.sacurrent.com/news/a-tale-of-two-texas-pool-parties-2551001

After a month of bar banger abuse, it seems to have held up well. Mushroomed as has been reported, but no one has complained about its performance. It is reshaped and ready to get thrown back into the lions den. Not sure if is my lathe speed or my technique but I did not get the glassy smooth...

There is. Look at my post above.

What is the real difference between generic tubes and others? Or are the tubes similar and the plug and vault plate the cheap part?

After one of the updates it stopped auto asking. Before you pick the picture, click the “Options” at the bottom to pick the size. For the ios18 update it looks like this.

Pretty simple process for the shaft, but you have to take it slow and be patient. Much of the thicker outer layer could be picked at with a razor blade and peeled off. Once I got it as even as possible I sanded the rest off and re finished. I did not do the butt. For the amount of work it...

Thanks for the help. After doing a little more searching and reading I did settle back to the .760 which I just ordered from Sterling (very nice people). About a 4 week wait time. I am still leery of the thinness of the forearm. I figure if I need to, I could stop short of the end and bore the...