Search results

The laminate trimmer that came with the Hightower Lathe should be the porter cable Model 7310.There is not an upgraded collet and nut setup for that laminate trimmer. Now if my memory serves me correctly Hightower sells an adaptor sleeve that goes from 1/4 to 1/8 inch. Hope this helps.

The Ultra-precision collets will not work with that porter cable trim router..

To the top.............

Actually this machine has a Gecko drive and has 20000 steps per inch inconjunction with kerk motion lead screws and antibacklash lead screw nuts. This machine holds very tight tollerences.

pm sent.........

There are now three video links in the original post..

http://www.motionbox.com/videos/1c99dcb61f1ae7ce94 http://www.motionbox.com/videos/4c99dcb61e18e2c4c4 http://www.motionbox.com/videos/d499dcb61f1be7c55c

King of Prussia, PA www.superbilliardsexpo.com

Just to let everyone know I am trying to get a few videos of the machine doing a part, pocket and a taper pass on a shaft.

Just to let everyone know I am trying to get a few videos of the machine doing a part and pocket.

I am ready to sell my cue monster. I purchased the machine new from Unique in late 2005. The machine will include a e-machine pc tower only with Desk NC and bobcad Ver.17 loaded on the machine and the factory IBM thinkpad laptop, Quiet Router with 1/4 and 1/8 collets, custom live center (that I...

Okay folks the pics are finaly posted in the original post...

Hey I resent that remark:grinning-moose::grinning-moose:

yea maybe he can take the Zian rd exitand get lost for an about an hour like you did..:thumbup::thumbup:

No I am located in New Lexington Ohio Its about 60 miles south east of columbus

I am ready to sell my cue monster. I purchased the machine new from Unique in late 2005. The machine will include a e-machine pc tower only with Desk NC and bobcad Ver.17 loaded on the machine and the factory IBM thinkpad laptop, Quiet Router with 1/4 and 1/8 collets, custom live center (that I...

up by Cleveland

So what is the deal with these tips. How do they preform? Is there any known problem with them popping off because of there hardness?? Thanks in advance

Sorry folks Wrong Area....

how are you going to put a patent on a taig lathe setup???