Search results

You might better check on your end. I have not seen a purchase come through today.

I have made that type of ferrule insert from Tomahawk for CF tubes. Being lightweight but very strong, Tomahawk works very well for that type of design.

I have had two reports (Mr Vmax, I don't know if you were one of them) of break tips not staying on black Tomahawk capped ferrules. It is only the black and only breakers. These days I am mentioning this to purchasers any time black ferrule material is purchased. I have a new supply of black...

This might be tempting in a few more days... :o

Traditionally, it is "butt wood into forearm" named.

Spoken for.

Thanks Gary!

Price dropped to $20 plus shipping.

Thanks, yours.

4, 5, 6 spoken for

Thanks, PM sent.

My Canadian brethren are good by me. They are yours. PM sent.

These are surfaced to 1.35 x 24". They are not the blackest, a couple checks here and there, anda few scattered pin holes. $12.50 a piece plus actual shipping.

Three rounds for sale (I want to sell all 3 to one person) 1-3/8 x 18" $25 plus actual shipping

I needed some coco squares....so...I'm selling some coco rounds. Makes sense, right? :rolleyes: What happened to the price of coco? The shortest on the far left is 23". The one on the far right is just shy of 26". The diameters range from 1.305 (most common) to 1.32. I just took a very...

I think I am going to have to fall on the opposite side of the skeptical fence. The last veneered FS blank I delivered to Dzuricky, I did zero bumping after the initial turning. Bob made the video before he took any additional cuts. Bob said he shimmed the joint center only .008" to dial the...

Any cuemaker with a lathe with a large enough spindle bore that is set up for both tapering butts and shafts on the lathe can taper one portion with half the cue in the headstock and hanging out the back, then reverse it and taper the other end and meet in the middle. So a lot of guys could do...

The only challenges are logistical. Can someone who makes FS sneaky blanks have a 48" "forearm" hang off their machinery when cutting the grooves. Does the same cuemaker have a lathe with 60" between centers to turn down a full length cue. The 60" between centers for cuemaking pretty much...

The owner liked your direction (at least I think he saw it and it wasn't a coincidence). "The Wizard King" (That makes me think of playing Telengard during junior high school.)

Very nice work.