Search results

Hi All, Would like to seek some advice involving a process during pin changing. There are times when a plug is needed while changing from one pin to another due to various reasons such as different pin size, different TPI etc. Does the material of the plug matter in this case? Or basically the...

Hi all, Would like to seek advice on procedures and pointers when installing pins such as 5/16-14, 5/16-18, 3/8-10, 3/8-11 etc which are commonly sold as fully threaded screws with no self-aligning barrels. Is it common that there will still be very slight wobble after installation for pins...

Hey all, Was working on a pin change recently and I had to support the butt on two ends with delrin collets that came with the lathe. The outcome of the pin change turned out satisfying. But, both ends where the collets were "grabbing" onto made deep circular marks around the cue. At the end...