Search results

Radial and uni-loc .842 .845 Other joints and sizes im possibly interested in also

Anyone have a cue man inlay machine laying around they'd be willing to part with. I remember one for sale awhile back but not sure if it sold or not

I'm in need of a taper bar set up if anyone has one sitting around

Had this happen twice recently. Both were medium speed very slight cut and when the cue ball hits the object ball the object ball jumps a little and I missed by a mile. In both cases the balls are pretty clean looking What causes this and is there a name for it.

So far I've got it at $80 but 3 days to go 🤞

Gotta build another blind shaft to match up

Building a carbon shaft blind. Seeing if anyone could mic there's

Need to make a matching ring. I know I've seen it many times but can't remember where or what it's called

I can't get my points perfect, sometimes there 1/8" off, sometimes 1/4" and rarely acceptable. Is there a way of adjusting them to perfect?

I'm wondering if there's a screw in adapter to use an extension with. About 5/8" hole and very course thread

Any ideal what grips they use? I felt a newer ikon and it looks like leather but is extremely grippy almost like rubber

Curious if there's any thing that'll bring out the woods character better before finishing with clear

Anyone know the joint diameter they use?

I'm fairly new at all this but anyone interested in pm me a wood supplier? I went to place an order with my normal supplier for some bird's eye and curly maple and they are out and have been for awhile now

Looking for 13mm + blank. I'm not seeing any around for sale

Is it feasible to add weight under the pin rather than to the butt, I'd rather have it a bit weight forwarded

Any suggestions on where to look for some teal colored juma or anything else that would work as a joint and butt cap

I stream youtubetv instead of paying for cable tv and added a sports channel package today so I can watch Motorcross live and to my surprise there is a dedicated billiard only channel 👍

What's my cheapest route to go to logo a carbon shaft? Tried the water slides and it just doesn't look good to me and not ready to take on the cost of a CNC yet. Laser maybe or a smaller cheap CNC of some kind?

I'm small time as compared to most but can make a big dusty or chemical mess quick that I'm not wanting to breathe anymore. A shop vac hose near the lathe basically does the job but is so noisy that I hate turning it on. So I'm basically going to run 2" pipe with off shoot hoses or similar...