Search results

  1. C

    Looking for help with cue case inserts Please

    Hi I am looking for the tubes that hold the shafts and butts inside a cue case. Looking more for individual tubes like golf club tubes. Needless to mention I would be needing the 2 different sizes to go along with the standard butt and the shaft sizes. Any ideas or recomendations? Tx a lot in...
  2. C

    F/S Meucci Red Dot Sneaky Pete

    Check out the attached pics, they should speak for themselves. The bottom end had a small chip. It was professionally re-finished by Todd Elkins (Richmond, VA) of Parrot Cues. Good old school Meucci Sneaky Pete with a Red Dot shaft. It has been one of my most favorites but I recently got a...
  3. C

    WTB: Looking for a 1st gen predator 314 shaft with 3/8x10 joint

    PM me with offer and picture please
  4. C

    FS: Barely used Mcdermott I2 Shaft with new tip

    Barely used since I purchased this about 6-8 months ago. Take a look at the pics to have a sense of current conditions. Personally - Its in great condition and rolls dead straight. Not to mention I read on AZ that Mcdermott will put a new tip on it for free if u pay for the $21 shipping...
  5. C

    31in long Jacoby custom shaft for 3/8x10 pin

    The shaft is used but rolls straight and has no warps. It has nice joint rings work and a brand new Kamui Super Soft tip on it. Tip size is just at 12.5 mm. The thread size fits a 3/8 x x10 (standard Mcdermott). The shaft is long and measures at 31 inch. Please see pics below. Shoot great...
Back
Top