Search results

Can anyone shed some light on these two vintage cues? Any thoughts or info appreciated. Helmstetter cue with original and Kilby shaft. What is Ap/6? Is '1 of 1' actually a 1 of 1 cue? Age? Value? Brunswick cue with original shaft. Unusual cue as the forearm is square and lots of inlay. Is this...

A couple of old cards I came across. I'm familiar with Hal Mix but have no info about the 'BEHIND THE EIGHT BALL CLUB'. Any of you old timers recognize this club?

I'm curious to know which cue makers do wood pin joints commonly used in 3-cushion cues? Also, I have a couple of Hoppe Titleist cues and was wondering if someone knows of anyone who has done a conversion with a wood pin?

Can anyone identify this cue? I'm thinking it is a carom cue. Short 56", light 16 oz. It has matching numbers stamped on the butt and shaft (#458). The butt is painted black, not sure if that is original or applied later. The joint is brass. Note Palmer/Viking like plastic for the butt cap. It...

This is a Predator Z2 shaft. I believe the original tip diameter was 11.75mm (.4625 in.). I bought this used and the tip is currently about 10.72mm (.422 in.). The ferrule length is short about 3/8". I use this as a carom (3-cushion) cue. I realize this is a small diameter to use for the large...

Just wondering if anyone knows of any suitable places to play 3C in Denver? I checked the USBA website and found none!

Simonis cost about $70 more. Opinions please, which do you prefer? Is one better then the other, or is it the installation/stretching that's more important?

I'm seeking information about the heater system on a Chevillotte carom table (Europa model, I believe - steel frame with inverted tripod legs), The light on the transformer is on but there is no heat to the slate. I'm guessing the wire heating filament is somewhere burnt in two. It appears there...

I'm seeking information about the heater system on a Chevillotte carom table (Europa model, I believe - steel frame with inverted tripod legs), The light on the transformer is on but there is no heat to the slate. I'm guessing the wire heating filament is somewhere burnt in two. It appears there...