Search results

More info required like is it a 90vdc motor or a 180vdc? pics and specs.....

Depends on how thick the leather was, or how deep the channel is now. Most linen is about .025" thick, compared to leather that can be .030" and thicker. I have used 5 minute epoxy to coat the whole channel and then re-cut the channel to the proper depth, and have had to use wood veneer applied...

I just ordered last month, took a couple weeks but got them. He also answered both my emails.

Did you buy this brand new? The reason I ask is that EVERY BK2 I've worked on has a carbon fiber pad on top of the 'ferrule' and If the pad is removed, you will see an exposed carbon tube end and the exposed ferrule edge....I have NOT seen one that has a Capped ferrule. The wood shaft BK's have...

found a place that carries the board.....HERE

It is actually a type of rotary switch with micro resisters soldered in between the connection posts.

Has anyone had an issue with the consew CSM-550-1 motor running at full speed no matter the setting of the pot? Mine was fine to center drill a hole....then 1 minute later went to finish drilling it and it's at full 3000+ rpms with no adjustment. I did check the pot with an ohm meter and it and...

I already knew the answer....I assume you didn't, otherwise you would have provided the same info based on (obviously large amount of knowledge) your own expertise.

Okay, how much experience do you have building cues, especially masse cues? I have 28-30 yrs of building cues, and have only built one masse, BUT I followed Dennis Diekman's writings about them I did my research.....(yes I have copies of his writings about masse cues and NO I will not share) He...

From Google AI: Massé cues are typically heavier and shorter than standard cues to facilitate high-spin, curved shots, with weights commonly ranging from 18 to 25 ounces. While some players prefer lighter massé cues around 19–21 oz, specialized massé cues often weigh around 25 oz to provide...

Bump

BUMP

Should be done by a competent cue repair guy. Maybe it can be 'done' by hand....but..... would it be done right without any damage to the front of the shaft? It is a phenolic type material, NOT a fiber pad.

BUMP.....open to reasonable offers on the boring head

Have a 14 piece set of er20 collets that are metric. These are brand new in the box. Price is $30 shipped to the 48 states. Second item I have is an American Sun type 400-1 boring head. It has an MT2 Shank. Price is $ $80 shipped to the 48 states. All payments are through PayPal friends/ family.

e is another example that is actually for a pool shaft.....here

Is it this one? It does not say quick release like the other one on their site. It is only $25 just like the quick release. Adaptor

From Google searching McDermott VQR AI Overview The McDermott Defy (VQR) is a high-performance carbon fiber pool cue shaft featuring a Viking Quick Release joint, designed to fit Viking cues

When planning the dust collections, remember to: ground the pipes, and put a cleanout access on every run.....

orange phenolic 2mm here