Search results

https://billsbilliards.com/ I've only tried the Endurance tips so far. I liked the install, and how they play.

Guys, I'm awful sorry, but I finished it yesterday, and was letting some folks try it out at the poolroom for feedback, and a guy really liked it, so yeah, I sold it to him. I've got another blank that I'll finish for further review. As far as my thoughts... It felt very solid, and I liked the...

You may be right, I don't have it finished yet. Been swamped with customer cues of late. The glue lines are not noticeable currently, but I have another 1/2 MM to remove. I'll take close up pictures, and give a full report as soon as I can. Thanks for your comment.

That's what i was told as well. I do think it was originally set up that way, but I don't know for sure.

I agree. I just used what I thought everyone was using the most.

I sure will sir!

We need both in my opinion. I can't tell you how many young friends I've cautioned about going too low with pocket size on their home tables. They often talk about 4" or 3 7/8 pockets with gleam in their eyes. Yes, this will improve you ball pocketing skills, but you miss out on another...

https://forums.azbilliards.com/threads/new-dominiak-kielwood-blanks.561675/

Just got this in the mail. Haven't had a chance to finish it yet. Always hard to find time to work on your own cue lol. But, it looks really great! Excited to see how it hits! This is the first radial laminated Kielwood shaft I've seen. He sells them in different grades all the way to ready to...

My fault, hard to see with the measure i had, and these old eyes. 1 7/16. Thanks!

That makes so much sense, but wouldn't they know it was off when they measured the rail height?

Can you cut away most of the folds to make it lay better, or should you start over?

Wont it sit uneven because the staples are not in?

I'll look again. Maybe i misread the ruler. Sorry for the late reply, and thanks for taking the time to answer my questions.

Sorry i haven't got back sooner. Ton of cue work. The bottom pic shows a difference where it's bare, and the top pic shows felt stapled all the way around. So the rails in the bottom pic would sit lower?

Fascinating! I have experienced tables like this and have never understood why it was happening since the installer would quote the rail height you mentioned earlier, and even measure it. This is mostly on bar boxes. Maybe this is a question for another time, but how do you make rail height...

Rapid Fuse. All I use.

Thank you sir!

I repair cues. Been at it since 98. Somehow I acquired a shaft shaped like a triangle. Folks try new, or what they think is new ideas all the time. I've played with it, and it's not bad at all. Really good off the rail.