Search results

  1. A

    screws or bolts?

    I am getting ready to put my slate on the table i purchased. It was held down with 2 inch #12 screws. These screws dont go all the way through the wood carry beams. I was thinking that it might be better or easier to level if i used machine fine thread bolts and nuts and pre drill through the...
  2. A

    3 piece slate warp

    Got the table i purchased pulled apart and the glue cleaned off the table. The slate is 3/4 inch. Two of the pieces seem pretty dead on, but one piece is out approx 1 mm in the center. its dead flat side to side all the way along it but across the short distance of the piece there is a belly in...
  3. A

    floating floor

    I am redoing a room in my basement and using floating floor/laminate. I am hopeing to be able to install the table in this room. Are there any considerations to this? The table is a standard 88*44 playing surface 3/4 inchs slate. My main concern is will the table shift as people move around it...
Top