Search results

Can anyone send me Leon's contact information? The phone number I have has been disconnected. Thanks.

I'm looking for a 3 piece slate 8' pool table in Maryland. I prefer playability over aesthetics... not looking for a "furniture table" and would like >7/8" slate. I'm planning to move the table professionally and install Simonis 860 cloth (and new rails, if needed). Max budget is around...

Thanks for the responses everyone!

Can anyone recommend a good mover / table mechanic in the Baltimore, MD area?

SS360/2 shaft. Purchased as a blank and finished by Bob Frey in MD, so there is no logo on the bottom of the shaft. Tip: UltraSkin M Weight: 3.22 oz Joint: 3/8"x10 There are two dings on the shaft near the tip (see pictures), but it's in good shape otherwise... no rolls, and no chalk stains...

*** SOLD! *** Custom cue built for me by Bob Frey a couple years ago. It's been very well taken of...spent most of it's life in a closet. Four points ebony into birdseye maple with four veneers: natural/black/red/black. Stainless steel flat-faced joint with radial pin. Black leather wrap...

Mezz WD700 low deflection shaft. 12.5mm, Kamui Black S tip, standard 5/16x14 thread (*not* united joint), 3.99oz, black with silver ring. Very clean - great condition. Purchased directly from Mezz in 2013 for $270. Asking SOLD! Note: There is no Mezz logo on this shaft. It was paired with a...

Joss cue Interested... PM sent.

Thanks for the replies!

Does anyone break with a cue that has a Juma ferrule? Have you experienced any cracking or mushrooming? I recently got a new shaft for my playing cue and am curious how it will hold up to the break shot.

price lowered! bump again for reduced price

bump bump again - considering trades too... make me an offer

bump again - any offers?

Bob is a wonderful guy. I have two fancy sneakies from him that are both great looking and tremendous playing cues. I've also seen one of his Titleist conversions first hand - the guy does great work and couldn't be easier to work with. I definitely recommend him, especially if you're local.

bump......

PM replies sent. Note: The shaft was purchased directly from Mezz with a 3/8x10 joint - it was not modified later.

I have a Mezz WD700 shaft that I'm looking to sell. I've only had it for about 5 months and it's in great condition. It's a very clean shaft - no chalk stains, smooth, rolls straight. There is a small dent at the bottom of the shaft near the collar (I did my best to capture in one of the...

Got my tips, had one installed today. Very impressed! Thank you Tom!

I've been itching to try these tips!