You are mistaken.
If I'm mistaken, then please, show me the black veins running across any real slate. Real slate don't have them because sticker boards are not used to separate the pieces for drying, therefore no black vein lines.
You are mistaken.
Thanks, Jerry! I'll have to have you and Dave over once the table is setup. I estimate early September which should give Steve plenty of time to do the rail work and me time to complete the restoration and build a matching light.
I want you to think about something if you will. BRUNSWICK shut down their slate mines to help support the war effort during WWll, and NEVER reopened them since....so, where did Brunswick get real slate from in the later 40's through the early 70'? Italy wasn't producing slates at the time, neither was Brazil. So, where did Brunswick get the REAL slate from? And guess what else, AMF was using Brunstone in their pool tables at that time, as well as MANY other manufacturers, they bought from Brunswick. Saulnier Wilhem used the Brunstone in their pool tables as well.
So, where did Brunswick get their real slate from to include them with the GC1's?????
Instead of insisting that I post photos (which you will immediately discredit), why don't you post a verifiable source for this story that you continue to tell?
I have worked on my fair share of early Brunstone Gold Crowns. I have also seen just about as many early slate Gold Crowns. The difference is obvious, so don't bother suggesting that I don't know what I'm looking at.
I don't know where Brunswick sourced their slate from. Frankly, I don't care. I know what I've seen, and the stories that you tell don't add up.
Back to the whole point regarding this thread, the OP has a slate table. In my opinion, that makes it more valuable.
This may add fuel to the fire, but here is a pic of a section of the playing surface.
This may add fuel to the fire, but here is a pic of a section of the playing surface.
That is Brunstone. Just slightly reddish and kinda gritty.this what was on mine and got me some cone
Sent from my iPhone using Tapatalk
This may add fuel to the fire, but here is a pic of a section of the playing surface.
Do you see your corner pocket cut out, it looks like the shelf is straight up and down except for the slight round over at the top edge....is it straight down, or at a slope down??
Beautiful work so far, rexus31!
~ K
I want you to think about something if you will. BRUNSWICK shut down their slate mines to help support the war effort during WWll, and NEVER reopened them since....so, where did Brunswick get real slate from in the later 40's through the early 70'? Italy wasn't producing slates at the time, neither was Brazil. So, where did Brunswick get the REAL slate from? And guess what else, AMF was using Brunstone in their pool tables at that time, as well as MANY other manufacturers, they bought from Brunswick. Saulnier Wilhem used the Brunstone in their pool tables as well.
So, where did Brunswick get their real slate from to include them with the GC1's?????
I assume we mean stacker, not sticker boards and I believe we can see the marks here in this example
Sent from my SM-T830 using Tapatalk
Yep, and if you run your fingers over it, you can feel its slightly raised at the edges. That don't happen when its slate that has been ground flat.