If the socket cap screw is threaded you could just get any normal bumper with an embedrd washer and the correct thread bolt.
Personally,
I would get the bumper from Pete ….
These bumperless cues seem to be very slippery on carpet and tile floors-
the last one I had sure was"
My point-
you keep it bumperless and your cue slips and falls to the floor- or against a pool table or furniture and cause serious damage-
up to Snapping the forearm-
"I've seen it happen"
just my 2 cents :wink:
BTW-
post pics of the entire cue-
sure looks sharp
sharp, it is...thx...
here you go: