New kid on the block here with what is probably a simple question regarding joint pin installation.
Task ahead is to install a 5/16 x 14 self-centering pin. Understand and can achieve the boring successfully, but not having much luck in identifying the appropriate tap drill for the 5/16 x 14 anchor. Can look up the sizes for 18 and 24 tpi – but 14 isn’t listed in the resources I’m reviewing. Any thoughts from the veteran makers?
Thanks in advice and look forward to learning much from this group.
Ken
Task ahead is to install a 5/16 x 14 self-centering pin. Understand and can achieve the boring successfully, but not having much luck in identifying the appropriate tap drill for the 5/16 x 14 anchor. Can look up the sizes for 18 and 24 tpi – but 14 isn’t listed in the resources I’m reviewing. Any thoughts from the veteran makers?
Thanks in advice and look forward to learning much from this group.
Ken