Marking the table

C

Ccarroll

AzB Silver Member
Silver Member
Does anyone have an example of an accurate way to mark the cross at the foot spot for racking and the breaking area "kitchen" line.
 
R

RiverCity

AzB Silver Member
Silver Member
Take a pencil or pen and lay it lengthwise on the table with one end of it close to position. Take a tape measure and center it between the long rails. Then use that same 'center' measurement from the end rail to the end of the pen. Mark a dot with a sharpie, then you just center your spot on the dot.
 
ceebee

ceebee

AzB Silver Member
Silver Member
I've always used a "Chalk LIne" (snap line) to start off with, center diamond to center diamond, on the long & short rails.

Then I use a medium marksalot.
 
RobMan

RobMan

AzB Silver Member
Silver Member
Or you use a laser like you get at bib box stores for hanging pics etc. I use tailors chalk - or a chalk pencil you get an an art store like Michaels. Less a while and if you mess up, you just rub it out.
 
You must log in or register to reply here.
Top