9' gold crown iii question

amc87

amc87

Registered
I am currently reassembling a gold crown iii. I was going to replace the felt. I have noticed a few impressions in two of the rail bumpers. So i am going to order new cushions for the table. The other cushions look good. Do i need to replace all six cushions or can i replace just the two? Also what kind of glue/epoxy should be used for this? Any info would be appreciated. Thanks
 
fastone371

fastone371

Certifiable
Silver Member
If it was my table I would without question replace all the rubber for the sake of consistency at the minimum. I believe that when you buy the cushions they come as a whole set for the table, they are not sold individually.
 
amc87

amc87

Registered
Yes you are correct they do come as a whole set. What is the best glue/epoxy to use?
 
D

duc996

AzB Silver Member
Silver Member
Contact cement is what is usually used. If you can find some contact cement made by 3M......hope that helps

amc87 said:
Yes you are correct they do come as a whole set. What is the best glue/epoxy to use?
Click to expand...
 
You must log in or register to reply here.
Top