2 piloted 5/16x14 shafts for trade - Joss West(?), and a Prather sneaky pete shaft

I have 2 shafts that I would like to trade for something, because I have no use for either of them.

I have are an old 5/16x14 shaft (that I was told was a Joss West shaft), and a sneaky pete shaft that I was told was made by Prather. The joint collar on the Joss West shaft (if it is a Joss West shaft) was replaced with a black collar and needs to be refitted and glued back in to place. The Joss West(?) shaft will not fit on my Predator (only screws about half way down), but was told that it would fit on an older Joss cue from the 90's. The Prather shaft will fit on the Predator, but the pilot it too big to fit all the way in to the predator butt to be flush with the joint.

Both of the shafts are straight, and in good condition (no nicks).

The Joss West(?) shaft is around 12mm, and the Prather shaft is around 13mm, but I do not know the exact sizes, because I do not have a caliper.

Here is a thread I created about the Joss West(?) shaft, so please read all of the replies if you are interested.

http://forums.azbilliards.com/showthread.php?t=355552

Thanks.
 

Attachments

  • DSC01672.jpg
    DSC01672.jpg
    68.8 KB · Views: 288
  • DSC01673.jpg
    DSC01673.jpg
    100 KB · Views: 365
  • DSC01674.jpg
    DSC01674.jpg
    100.6 KB · Views: 364
  • DSC01675.jpg
    DSC01675.jpg
    88.4 KB · Views: 291
  • DSC01676.jpg
    DSC01676.jpg
    90.5 KB · Views: 293
I don't i have any trade, but am interested in the sneaky pete shaft. How much would you want for it, and can you stick a toothpick or something into the insert and measure how deep it is?
 
Back
Top