3/8-10 HO Tap

[screamingelvis]

Does anyone know where I can pick one up Atlas has been out for some time?

Thanks Jim

 

[JBCustomCues]

They have them made. But why would you even want a zero limit tap. The OD of the pin is not perfect so it kind of defeats the purpose.

 

[FLYINGSNAIL]

http://www.prathercue.com/drills_taps_end_mills/drill_taps_end_mills.html

 

[screamingelvis]

They have them made. But why would you even want a zero limit tap. The OD of the pin is not perfect so it kind of defeats the purpose.

The argument at one point was you can get a tighter fitting shaft with it. Had been using 3/8 308 minor but want to change to a reg 3/8-10 pin. Perhaps a 3/8-10 plain tap will fill the bill anyway.

Jim

 

[jkan101]

tap

try here http://www.victornet.com/cgi-bin/vi...departments=Special+Thread+Taps:618,1170,1171