314 shafts on a BCM?

D

destroyshit

AzB Silver Member
Silver Member
Does anyone have a 314, 314.2 or OB-1 on a BCM? I was wondering how they fit since the pin is not a full 3/8 and the joint is smaller than most? Do they still fit snug or loose?
 
Last edited:
if the BCM pin is the 3/8-10 i think it is the regular 3/8-10 shafts will fit loose.
 
pin size.

the pin is 3/8x11. but it's not a full 3/8s. 3/8s is .375, he uses a .360 pin.
 
Last edited:
destroyshit said:
Does anyone have a 314, 314.2 or OB-1 on a BCM? I was wondering how they fit since the pin is not a full 3/8 and the joint is smaller than most? Do they still fit snug or loose?
Click to expand...

Contact Bryan and share your concerns with him. He better than anyone about how they will fit.
http://www.bcmcue.com/
 
314

Bryan said he it depend on how the shafts are produced, so he isn't even sure. Nobody on here has a 314 on a BCM?
 
Last edited:
You must log in or register to reply here.
Back
Top