360 Pure Stroke Trainer - Joint Pin Question

suharsh

Registered
I tried searching but couldn't find which pin it uses! I have the cue but the shaft that it comes with is 13mm+ and I intend to replace it with a thinner shaft, hence the question.

It certainly is not 5/16 x 14 and neither is it 3/8 x 10 ... those shafts I have didn't fit.

My guess is that it is 5/16 x 18. Hopefully someone knows.
 

Patrick Johnson

Fish of the Day
Silver Member
I tried searching but couldn't find which pin it uses! I have the cue but the shaft that it comes with is 13mm+ and I intend to replace it with a thinner shaft, hence the question.

It certainly is not 5/16 x 14 and neither is it 3/8 x 10 ... those shafts I have didn't fit.

My guess is that it is 5/16 x 18. Hopefully someone knows.
The fraction is the outside diameter in inches (for example 5/16" diameter). The whole number is the number of threads per inch (for example 14 per inch). You can measure it yourself.

pj
chgo
 
Top